Working Method - Husqvarna AUTOMOWER 405X Bedienungsanweisung

31.5 Working method

®
Automower 405X/415X use GPS-assisted navigation
to start mowing in a place in the yard where it has not
been lately. It is also possible to use the
function to make manual settings to guide the product to
remote parts of the work area, refer to the complete
Operator's Manual on Husqvarna's website.
When the product hits an obstacle or approaches the
boundary wire the product reverses and selects a new
direction. Sensors at the front and back will sense when
the product is approaching the boundary wire. The front
always passes the boundary wire by a specific distance
before the product turns around. The distance can be
changed to adapt to the installation if required.
74 - Introduction
The STOP button on the top of the product is mainly
used to stop the product when it's running. When the
STOP button is pushed a hatch opens, behind which
there is a control panel. The STOP button remains
pushed in until the hatch is closed again. This together
with the START button acts as a start inhibitor.
Note:
Lawn coverage
the hatch to start the product. If the START button is not
pushed, a message beep is heard and the product will
not start.
Note:
start-up sequence begins which includes a number of
important basic settings, refer to
in the complete Operator's Manual on Husqvarna's
website.
31.6 Finding the charging station
The product can be set to search for the charging station
in up to 3 different ways. The product automatically
combines these 3 search methods to locate the charging
station as fast as possible, but also to avoid as much
tracks forming as possible.
Always push the START button before closing
When the product is started for the first time, a
To do the basic settings
1508 - 004 - 22.12.2020