Silvercrest homematic HmIP-SWDM-B2 Bedienungsanleitung Und Sicherheitshinweise Seite 49


Press the System button of the device to be taught in (for
example, the SilverCrest Smart Home radiator thermostat) for at
least four seconds to activate the teach-in mode. The device LED
begins to flash orange. Further information regarding this can be
found in the operating instructions for the respective device.
The device LED flashes green to indicate that the teach-in process was
successful. If the teach-in process was not successful, the device LED
will turn red. Try it again.
The teach-in mode is automatically ended after three
minutes if no teaching in takes place.
If you would like to add another device to the existing
devices, you must first put the existing device into teach-in
mode, then the new device.
If, for example, you would like to add another radiator
thermostat to the existing devices, you must first teach in the
new radiator thermostat onto the existing radiator
thermostat. Then you can teach in the new radiator
thermostat onto the existing door and window contact.
If you use several devices in a room, you should teach in all
devices onto one another.
HmIP-SWDM-B2
English - 47