Silvercrest SAD 130 A1 Bedienungsanleitung Und Sicherheitshinweise Seite 43

The procedure for filling is as follows:
• Lift the shade (2) up out of the aroma diffuser.
• Next remove the lid (3) from the water reservoir (4).
• Put a few drops of scented or essential oil into the water reservoir (4) in accordance
with the manufacturer's recommendations.
• Fill the water reservoir (4) with water. For correct operation, at least the base of the
water reservoir (4) must be covered completely with water. The maximum water level
is shown by the Max marking (arrow) on the water reservoir (4). The water must not
be higher than this marking.
• Place the lid (3) back on to the water reservoir (4).
• Then place the shade (2) back in the aroma diffuser.
The aroma diffuser is now ready for you to use the diffuser function.
SilverCrest SAD 130 A1
English - 41