Intended Use; Before First Use; Adjusting The Headband To The Head Size - Westfalia 94 90 98 Originalanleitung

Intended Use

 This auto-darkening welding helmet is designed to protect your eyes
and face from sparks, spatter and harmful radiation under normal
welding conditions. The auto-darkening filter automatically changes
from a light state to dark state when an arc is struck.
 The intended use also includes an operation following the operating
instructions.
 Any use beyond these parameters (different media, applying force)
or any changes (reconstruction, no original accessory) can lead to
serious risks and is regarded as use that is contrary to the intended
purpose.

Before first Use

Unpack the auto-darkening helmet and dispose of packaging material.
Plastic bags etc. may become a deadly toy for small children.
Remove the protection foils from the front cover lens and from the
inside cover lens.
Before welding adjust the position of the headband (8) according to
your requirements.

Adjusting the Headband to the Head Size

 Use the adjustment knob (10) at the rear side of the head band to
adjust the overall circumference of the head band according to your
requirements. Turn the knob counter clockwise to expand the head
band. Turn the knob clockwise to shorten the circumference of the
head band. Wear the helmet while adjusting the head band length.
Make sure the head band is sitting firmly but comfortable.
 Open the head band clasp (7) and adjust the length of the upper
head band piece.
 The front stop position can be adjusted with the locking pin (9).
Loosen the limit block nuts (5) and re-position the locking pin (9) into
the desired hole. Re-tighten the block nuts. To move the headband
back and forth loosen the block nuts (5) and move the headband to
a slot further back or forward.
Operation
16