Installing A Camera (Optional); Get More Out Of Your Device; Technical Characteristics - Philips WelcomeEye Connect Pro Bedienungsanleitung

9 – Refit the front cover of the intercom and tighten the tamper-resistant retaining screw.
10 - Connect the 230V AC power supply to the modular adaptor, for an installation compliant
with applicable standards (NFC 15-100 in France).
- Verify the smooth functioning (video call, RFID, etc.).
- When there is a second intercom panel, don't forget to configure the monitor(s).
11 - Attach a silicone seal* between the shield and the wall to stop flowing water.
*Do not use acetic acid-based silicone (vinegar odour).

5. Installing a camera (optional)

Connect the wires in accordance with the wiring diagram.
Choose a suitable place to install the camera.
Ensure that nothing gets in the way of the installation.
Screw the wall section with the screws provided (for solid walls).
Point the camera in the desired direction and tighten the retainer screw.
Configure the monitor(s)

6. GET MORE OUT OF YOUR DEVICE

To find out more about your Philips WelcomeEye product, you can download the complete
instructions at www.vestapro.eu

7. TECHNICAL CHARACTERISTICS

Monitor:
ref.: 531022 (WelcomeEye Connect Pro)
- 2 wires
- 7" touch screen
- Resolution 800 x 480
- Class 10 micro SD card up to 32GB (not supplied)
- Wi-Fi 2.4 GHz IEEE 8111 b/g/n
- Radio power emitted: 18 dB maximum
- Current consumption: 550mA
- Power consumption: 13.2W
- 6 ringtones (85dB)
- Dimensions: 142(h) x 210(l) x 15(d) mm
Intercom panel: (WelcomeEye Outdoor)
ref.: 531022
- C-MOS colour sensor 900TVL
- Viewing angle H150°, V90°
- Night vision (white LEDs)
- Strike plate control 12V/1.1A/ 1,5 s.
- Gate control: breaking capacity 12V/2A
- RFID (125kHz)
- IP44
- Operating temperature: -20°C / +50°C
- Dimensions: 168(h) x 82(l) x 38(d) mm
WelcomeEye Pro application (for WelcomeEye Connect Pro only):
GB9
On
WelcomeEye Connect Pro / V2
On