Cold Water Connection; Positioning The Appliance; Water Outlet; Extension Hose - Blaupunkt 5VT710NA Montage- Und Gebrauchsanweisung

WARNING!
A hose that attaches to a sink spray can burst if it is installed on the same water line as the dishwasher. If your sink has one, it is
recommended thet the hose be disconnected and the hole plugged.
How to Disconnect the safety supply hose
1.Turn off the water.
2. Release the water pressure by depressing the pressure release button. This relieves water pressure and protects you, and
the room, from severe splashing.
3.Unscrew The safety supply hose from the faucet..

COLD WATER CONNECTION

Connect the cold water supply hose to a threaded 3/4 (inch) connector and make sure that it is fastened tightly in place. If the
water pipes are new or have not been used for an extended period of time, let the water run to make sure that the water is clear
and free of impurities. If this precaution is not taken, there is a risk that the water inlet can get blocked and damage the appli-
ance.

Positioning the Appliance

Position the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent
cabinets or walls. The dishwasher is equipped with water supply and drain hoses that can be positioned either to the right or
the left sides to facilitate proper installation.
How to Drain Excess Water From Hoses
If the sink is 1000 higher from the fl oor, the excess water in hoses cannot be drained directly into the
sink. It will be necessary to drain excess water from hoses into a bowl or suitable container that is held
outside and lower than the sink.

Water Outlet

Connect the water drain hose. The drain hose must be correctly fi tted to avoid water leaks.
Make sure that the drain hose is neither kinked nor pinched

Extension Hose

If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.
Syphon Connection
Insert the drain hose into a drain pipe with a minimum diameter of 40mm, or let it run into the sink, making sure to avoid bend-
ing or crimping it. The top of the hose must be less than 1000mm.
Start of Dishwasher
The following things should be checked before starting the dishwasher.
1 The dishwasher is level and fi xed properly
2 The inlet valve is open
3 There is no leakage and the connections of hoses must be tightened
4 The power cable is properly connected
5 The power is switched on
6 The inlet and outlet hoses must not be entangled with each other
7 All packing materials and printings should be taken out from the dishwasher
Attention:
After installation, please make sure to keep this manual.
The content of this manual is very helpful to the users.
54