Herunterladen Inhalt Inhalt Diese Seite drucken

Prior Using For The First Time; A Water Softener; Adjusting Salt Consumption - Blaupunkt 5VT710NA Montage- Und Gebrauchsanweisung

Einbau geschirrspüler, vollintegriert
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
4�
Prior using for the fi rst time
Before using your dishwasher for the fi rst time:
A.
Set the water softener
B.
Add 1.5Kg dishwasher salt and then full fi ll the salt container with water
C.
Fill the rinse aid dispenser
D.
Fill in detergent
A� Water Softener
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which would have a detrimental or adverse
effect on the operation of the appliance.
The higher the content of these minerals and salts, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area. Your local Water Authority can
advise you on the hardness of the water in your area.

Adjusting Salt Consumption

The dishwasher is designed to allow for adjustment in the amount of salt consumed based on the hardness of the water
used. This is intended to optimise and customise the level o f salt consumption.
Please follow the steps below for adjustment in salt consumption.
1. Open the door, Switch on the appliance;
2. Within the fi rst 60 seconds after the appliance was switched on, press the program button for more
than 5 seconds to start the water softener set model (The Salt and Rinse aid warning lights will be
on periodically when it gets into the set model);
3. Press the Program button to select the proper set according to your local environment, the sets will
change in the following sequence: H4
4. Press the Power button to end the set up model.
dH
fH
0~5
0~9
6-11
10-20
12-17
21-30
18-22
31-40
23-34
41-60
35-55
61-98
Note:1
dH=1.25Clarke=1.78fH=0.178mmol/l
DH: German degree
fH: French degree
Clark: British degree
Note:2
The manufactory setting: H3 (EN 50242)
Contact your local water board for information on the hardness of your water supply.
NOTE:
If your model does not have any water softener, you may skip this section.
WATER SOFTENER
The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the
dishes and utensils.
The appliance is equipped with a special softener that uses a salt container specifi cally designed to eliminate lime and
minerals from the water.
WATER HARDNESS
Clarke
0~6
7-14
1.0-2.0
15-21
2.1-3.0
22-28
3.1-4.0
29-42
4.1-6.0
43-69
6.1-9.8
H5
H6
H1
H2
H3;
Salt c onsumption
Selector Position
mmol/l
0~0.94
H1
H2
H3
H4
H5
H6
37
(gram/cycle)
0
9
12
20
30
60

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis