Operation; Power Supply; Switching The Unit On/Off; Switching On The Unit - Bosch BEA 055 Originalbetriebsanleitug

4.

Operation

4.1

Power supply

Power is supplied via the integrated power supply unit
in the BEA 950.
!
If the BEA 950 is operated outdoors, it is advisable
to use a power source which is protected by a
ground fault circuit interrupter. The unit is only to
be operated in dry conditions.
!
To avoid the formation of condensation, allow the
BEA 055 to adjust to the ambient temperature
before switching the BEA 950 on.
i
The details of the power supply for the BEA 055 are
displayed on a sticker on the rear of the unit.
4.2

Switching the unit on/off

4.2.1

Switching on the unit

¶
Switch on the BEA 055 via the BEA 950.
"
Alternate orange and green flashing of LED (fig. 1,
pos. 14).
4.2.2

Switching off the unit

To keep contamination of the BEA 055 to a minimum,
it is advisable to flush residual gas out of the BEA 055
with the pump running prior to switching off. The
exhaust gas sampling probe must be in the open air
for this purpose.
i
First, exit from the exhaust gas test step and wait
for completion of pump run-on. Only switch off the
BEA 950 after this has completed.
¶
Switch off the BEA 950.
"
The LED on the BEA 055 is not lit up.
Robert Bosch GmbH
Operation | BEA 055 | 21 |
4.3

Start-up

4.3.1

Installing SystemSoft BEA-PC

i
Heed the system prerequisites before starting
installation.
i
Only plug in the Bluetooth USB adapter when
prompted to do so during software installation.
1. Close all open applications.
2. Insert the "SystemSoft BEA-PC" DVD in the
DVD drive.
3. Start "Windows Explorer".
4. Start 'D:\RBSETUP.EXE' (D = DVD drive letter).
 BEA set-up is started.
5. Confirm with <Continue>.
6. Heed and follow the instructions on the screen.
7. Re-start the PC/Laptop to successfully conclude
installation.
"
BEA is installed.
4.3.2

BEA 055 configuration

After installing the SystemSoft BEA-PC, the device
interface of the BEA 055 has to be set. The BEA 055
can be connected by way of either the USB connecting
cable or Bluetooth to a PC/Laptop.
1. Select "Start >> All programs >> Bosch >>
Diagnostics >> Central Device Communication" or
click onto " " in the task bar with the left mouse
key.
 CDC – Central Device Communication is opened.
2. Select "Settings >> Device interfaces".
i
Pressing <F1> opens the Online Help for a display
of the most important information on interface
setting.
3. Configure the BEA 055 in the GAM Group (USB or
Bluetooth).
 BEA 055 is ready for operation.
4. Start SystemSoft BEA-PC.
4.4

Program description

i
Refer to the Online Help for further details on the
BEA-PC system software.
en
|
1 689 989 111 2020-09-24