Technical Data - IKEA MATMÄSSIG Bedienungsanleitung

ENGLISH
Problem
There is no signal when you
touch panel symbols.
symbol plus a number
appears on the timer dis-
play.
lights up on the timer
display.
If there is an error, first try to find a solution
to the problem yourself. If you cannot find a
solution to the problem yourself, contact
your IKEA store call centre. You can find a
full list of IKEA appointed contacts at the
end of this manual.

Technical data

Rating Plate
Made in Germany
© Inter IKEA Systems B.V.
103.688.23
IKEA of Sweden AB
21552
SE - 343 81 Älmhult
Possible cause
The signals are deactivated. Activate the signals. Refer to
Electronic component error.
The second phase of the
power supply is missing.
Model MATMÄSSIG Typ 60 HAD 03 AO 6,5kW
PNC 949 594 428 00 S NO ............... 220V-240V AC 50-60 Hz
Remedy
OffSound Control.
Disconnect the appliance
from the electrical supply for
a few minutes. Remove the
fuse, wait one minute, and
insert the fuse again. If the
problem continues, ensure a
correct installation by calling
an authorised installer.
Check if the appliance is
connected correctly to the
electrical supply. Remove
the fuse, wait for one minute,
and insert the fuse again. If
the problem continues, en-
sure a correct installation by
calling an authorised instal-
ler.
If you operated the appliance
wrongly, or the installation was
not carried out by a registered
engineer, the visit from the After
Sales Service technician or
dealer may not take place free
of charge, even during the
warranty period.
17
230 V
DGT