Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The speed of the shaft is adjusted by changing the drive belt pulley.
1. To do so, open the belt array cover (50)
on the front side of the motor housing.
This cover is fastened in place by two
screws. In order to change the drive belt
over to another sized pulley, undo the
four bolts that hold the drive pulley in
place first using a size 10 Allen key.
2. You can now push the drive pulley
upwards until the drive belt loosens and
can be placed on one of the other pulleys.
The belt must run parallel when selecting
a transmission stage.
The rotational speeds of the individual
stages are shown in the drawing along-
side.
3. After you have placed the drive belt on the required drive and output
pulleys, pull the drive gear down a little until the drive belt is taut.
4. Fasten the drive gear in this position by tightening the four bolts around
the pulley again.
Important: There is a safety switch on the cover of the belt array (A) which
prevents the lathe being operated whilst the belt array is open. The machine
can only be operated after the cover has been closed tight.
Switching the Lathe ON and OFF
The ON/OFF switch (B) is located on the upper section of the motor housing.
The machine is switched on by pressing the green button and switched off by
pressing the red button. The switch has an undervoltage release. This means
that the machine does not start up again automatically after an interruption in
mains supply but has to be started again by pressing the ON switch.
When switching on the machine, make sure that the workpiece can rotate
freely and does not knock against the lathe bed (H and I) or the tool rest (D).
Make sure that the workpiece is clamped tight and cannot work loose.
Operation
17
Fig./Abb. 11
Werbung
Inhaltsverzeichnis
