Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
To use the wood lathe, you need an adequately sized workbench upon which
the lathe can either be mounted permanently or fastened in place with the help
of screw clamps.
Assembling the Lathe Bed
The lathe bed (H + I) is supplied in two parts. The
two parts have to be screwed together if you want to
turn long sections of wood.
To do so, use the four provided M8 screws (K). Use
washers (N) on both sides. To secure the nuts in
place, put the spring washers (M) on the screws (K)
before screwing on the M8 nuts (L).
There are a total of eight holes in the base of the belt
array (A) and the bottom rail of the lathe bed for
fastening the lathe onto a workbench. If you only intend to use the lathe
occasionally, it is advisable to fasten the lathe onto a workbench with screw
clamps. Use at least 3 screw clamps with one as close as possible to the
middle of the lathe bed in order to prevent the lathe bed from bending when
clamping a long piece of wood.
Assembling and Fitting the Tailstock
1. First of all, connect the provided hand wheel (20)
to the spindle screw (16).
2. Push the hand wheel onto the shaft and fasten it
in place by tightening the locking screw (19) with
the enclosed Allen key (U). Place the tailstock
(E) on the lathe bed from above.
3. Push the M18 screw (R) through the hole in the
base of the tailstock. Position the guide track
plate (Q) underneath and screw the clamping
lever (O) onto the screw.
Operation
13
Fig./Abb.3
Fig./Abb. 4
Werbung
Inhaltsverzeichnis
