Siemens CP 1401 Installationsanleitung Seite 74

SIMATIC NET CP 1401
IRQ Interrupt
Number Without
Default
Combination
Step
1
Select one default combination that is closest to your combination:
IF you use the interface module
interrupt IRQ...,
2 Install the software completely using the interrupt number you have selected
(default combination).
3 Find the following entry in the AUTOEXEC.BAT file:
This entry must be extended by a dash (-), the letter i and a number.
Example:
4 After the letter i, enter the number of the PC interrupt you are using in decimal
format.
Example:
You have entered the PC interrupt B
AUTOEXEC.BAT is then as follows:
© Copyright by SIEMENS AG
You require the information in this section if the
interrupt combination you have selected in the BIOS
Setup does not correspond to one of the default
combinations described above.
If the interrupt combination you have selected is not a default
combination, enter the interrupt number of the closest default
combination to your own combination as the IRQ. After
installing the software, you can then modify the resulting
entry in the AUTOEXEC.BAT file.
The exact steps are described below:
Description
a
b
c
1401DLI.COM
1401DLI.COM ...-i3...
in the BIOS Setup. The entry in
H
1401DLI.COM ...-i11...
72
S79220-A0707-A-02-7419
THEN select the interrupt number
(default combination)...
3
4
5