Silvercrest SOPE 650 A1 Bedienungsanleitung Seite 40

PROBLEM POSSIBLE CAUSES
The press screw
control lamp
green/red.
The appliance is
The ingredients are not feeding
working, but no
through.
oil is produced.
The oil content of the in gredients
used is too low.
There are foreign bodies among the
ingredients.
Depending on the composition of
the ingredients, there may be some
This appliance
loud and some less loud operating
generates
noises. You may hear some loud,
abnormal noise
squeaky operating noises,
during operation.
especially when processing small,
hard ingredients, such as chia
seeds. This is normal and is not an
appliance fault.
The appliance was not correctly
The appliance
assembled when the mains plug
is con tinuously
was plugged in, a safety device
beeping.
has tripped.
Press screw
The lock
housing
cannot be closed.
correctly in the mounting.
Funnel cannot
The lock
be mounted.
If the above suggestions do not resolve the problem, or if you experience any other type of
problem, please contact Customer Service.
SOPE 650 A1
is blocked, the
flashes alternately
and press screw
are not inserted
is not correctly closed.
POSSIBLE SOLUTIONS
Proceed as described in the
section "Removing a blockage".
Pause the appliance and carefully
push the ingredients with a spoon
or similar. Direction of the funnel
outlet.
Choose ingredients with a
sufficiently high oil content (see
section "The right ingredients").
Remove the foreign objects (see
section "Removing a blockage").
See section "The right
ingredients".
If the press screw blocks,
proceed as described in the
section "Removing a blockage".
Check that the appliance is
assembled correctly.
Wiggle the press screw
housing a little and try again
to push the lock in the
direction of the symbol.
Push the locking appliance
the direction of the symbol until
it stops.
GB │ IE
in
│ 37 ■