System Mode - Sony HR-MPS Bedienungsanleitung

2, 3
1
4
SONY
POWER
O·:©:·
PHONES _ , .
1
SYSTEM: Select
@IB:Q~~~~
[SETUP][CLOCK][MEMRY][PEDRL][M ID I l][M ID 12]
2
0 -0 -0 -0-0-D
- - - - - - FUNCTION
3
0 -0 -0 -0 -0 -D
- - - - - - FUNCTION
50
System Mode
This mode is used to configure the unit's six
main operation environments. To return to
the previous screen during setup, press the
EXIT button. To return to the play mode
(PLAY screen) after finishing making
settings, press the EXIT button a few times
until you return to the play mode (PLAY
screen).
1
Press the SYSTEM button.
The SYSTEM screen is displayed.
2
Select the function you want to
set by pressing the corresponding
FUNCTION button (A-F).
FUNCTION A button:
Sets the setup
function. The "SYSTEM: Set Up"
screen is displayed. (See page 52)
FUNCTION B button:
Sets the time.
The "System: Clock" screen is
displayed. (See page 52)
FUNCTION C button: Edits the user
memory. The "SYSTEM: Memory"
screen is displayed. (See page 54)
FUNCTION D button:
Sets the pedal
settings. The "SYSTEM: Pedal"
screen is displayed. (See page 56)
FUNCTION E button: Sets the MIDI 1
settings. The "SYSTEM: MIDI
BASIC" screen is displayed. (See
page56)
FUNCTION F button:
Sets the MIDI 2
settings. The "SYSTEM: MIDI RX-
SW" screen is displayed. (See page
56)
3
Select the item you want to set
from the screen displayed in step
2 by pressing the corresponding
FUNCTION button (A-F).
4
Turn the operation dial or use the
shuttle ring to adjust or change
the setting.