Operation; Maintenance - Husqvarna CA230 Bedienungsanweisung

Make sure the handle and safety features are in
•
order. Never use a product that has any parts
missing or has been modified in relation to the
specification.
• Only use the product for the purpose it was intended
for.
• Make sure the cutting attachment has stopped
before cleaning, carrying out repairs or an
To start the product with a cold engine
If you have a gasoline operated product, obey these
instructions to start the product with a cold engine.
Introduction
Below you will find some general maintenance
instructions. If you need further information please
contact your service workshop.
To replace the blades
WARNING: Always stop the product before
you work on any part of the attachment. It
can continue to move even after the throttle/
power trigger is released. If you have a
gasoline operated product, disconnect the
HT leads from the spark plug. If you have a
battery operated product, remove the
battery. Ensure the attachment has stopped
completely before you start to work on it.
1. Loosen the split pin.
2. Remove the cutter package from the gear housing's
output axle.
742 - 002 - 13.12.2019
inspection. If you have a gasoline operated product,
disconnect the HT leads from the spark plug. If you
have a battery operated product, remove the battery.
• Wear heavy-duty gloves when repairing the
cultivator.
• Use only original spare parts for repairs.
• Store the product out of reach of children.

Operation

1. Run the basic product warm and then shut down the
product.
2. Mount the accessory as per the assembly
instructions.

Maintenance

3. Mount the cutter package onto the gear housing's
output shaft. Make sure the direction of rotation
agrees with the cutters and on the gear. The arrows
must point in the same direction.
To perform daily maintenance on the
product
1. Check that the guard is undamaged and not
cracked. Replace the guard if it has been exposed to
impact or is cracked.
7