gasoline operated product, disconnect the
HT leads from the spark plug. If you have a
battery operated product, remove the
battery. Ensure the attachment has stopped
completely before you start to work on it.
1. Loosen the split pin.
2. Remove the cutter package from the gear housing's
output axle.
3. Mount the cutter package onto the gear housing's
output shaft. Make sure the direction of rotation
agrees with the cutters and on the gear. The arrows
must point in the same direction.
Transport and storage
If transporting the attachment on another vehicle always
use approved securing devices and make sure that the
attachment is securely held.
742 - 002 - 13.12.2019
Transportation, storage and disposal
To perform daily maintenance on the
product
1. Check that the guard is undamaged and not
cracked. Replace the guard if it has been exposed to
impact or is cracked.
2. Check that the blades do not move when the throttle/
power trigger is released.
3. Check that the blades are undamaged and show no
signs of cracking or other damage. Replace the
blades if necessary.
4. Check that nuts and screws are tight.
5. Clean the outside of the product.
6. Check that the split pins and cotter pins are
undamagad and secured correctly.
Ensure the attachment is cleaned and that a complete
service is carried out before long-term storage.
241