Setup / Initial Start-Up; Grinding Coffee Beans For Filter Coffee; Grinding Espresso Beans For Espresso - Silvercrest SKME 150 C2 Bedienungsanleitung

Setup / initial start-up

1) Clean the appliance as described in the
chapter "Cleaning and Care" .
2) Place the appliance on a suitable and level
surface .
3) Unwind the cable from around the cable
retainer 5 and guide it through the recess on
the edge of the housing .
4) Insert the plug into a mains power socket .
The appliance is now ready for use .
Grinding coffee beans
for filter coffee
1) Remove the lid 2 from the motor unit 3 .
2) Fill it with the required quantity of coffee beans .
NOTE
► Please do not fill the appliance with more
than 70 g of coffee beans . If you do, the
coffee beans will not be correctly ground .
70 g is equivalent to around 5 tablespoons
of coffee beans!
► You will require around 6 - 8 g of coffee
powder for one cup of coffee . Please observe
the instructions in the coffee-maker operating
manual .
3) Put the lid 2 on . Ensure that the switch
lies over the square recess on the edge of the
housing of the motor unit 3 .
4) Press and hold the switch
beans have been ground to your requirements
(around 30 seconds) .
NOTE
► During grinding, if coffee powder starts col-
lecting on the edge of the appliance where it
is out of the reach of the blade 4, shake the
appliance gently so that coffee powder falls
back inside .
SKME 150 C2
The coffee grinding grade is influenced by the
quantity of coffee beans added and the length of
grinding .
The longer you grind the coffee, the finer the coffee
powder . Shorter grinding results in coarser coffee
powder .
This is a rough guide .
5) Release the switch
6) Take the lid 2 off and disconnect the mains
You can now remove the coffee powder using
a spoon or similar . You can clear out residue using
the cleaning brush 6 .
1
Grinding espresso beans
for espresso
Coffee powder for espresso always requires very fine
1 until the coffee
grinding . Ensure that you grind the special espresso
beans for an appropriate time (approx . 45 seconds)
when preparing espresso coffee .
When grinding espresso beans, proceed exactly
as described in chapter "Grinding coffee beans for
filter coffee", and use the following guide values:
Grinding Recommended
grade
quantity of
coffee beans
Coarse
Medium
Fine
NOTE
► Please observe the information about the
grinding degree in the coffee-maker operating
manual .
beans have been ground to your requirements
and wait until the blade 4 is at a standstill .
plug from the power supply .
NOTE
► To reach the grinding grade needed for espresso,
we recommend grinding a maximum of 36 g of
espresso beans for around 45 seconds .
–
18 g of espresso beans for 2 cups of espresso .
–
36 g of espresso beans for 4 cups of espresso .
Time
in
seconds
70 g 30 s
45 g 30 s
36 g 45 s
1 once the coffee
GB │ MT │ 29 ■