Sony DSBK-120 Bedienungsanleitung Seite 20

Installation
9
Remove the two screws from
the cover plate on the rear
panel of the VCR to the right
of the QSDI connectors. Slide
the cover plate to the right,
then remove it.
Note
Retain the cover plate.
10
Feed the four cables out
through the holes exposed
when the cover plate is
removed, and connect them to
the connector panel, one of the
components of the DSBK-120/
120P.
Seen from the rear of the VCR,
red and black connector cables
pass through the right hole, and
the blue and green connector
cables pass through the left
hole.
Note
Be careful to match the cable
connector colors, and connect
them in the sequence shown in
the figure.
11
Attach the connector panel to
the rear panel of the VCR.
Pulling the cables back through
the holes, slot the connector
panel into position, then slide it
to the left. Fasten the
connector panel with the two
screws removed in step 9.
20
Cover plate
Red connector
Black connector
Blue connector
Green connector
Connector panel