Sony DSBK-120 Bedienungsanleitung Seite 18

Installation
2) Lay the SDI-27 board
alongside the DV-15 board
as illustrated, and pass the
two cables (connected to
the SDI-27 board in the
"Preparations" stage) over
the DV-15 board along the
illustrated route. Use the
three wire clips on the DV-
15 board to secure the four
cables (two from the SDI-
28 and two from the SDI-
27) on the DV-15 board.
3) Plug the connector of the
SDI-27 board firmly into
the connector on the DV-15
board.
Note
Take care that the cables
are not trodden under the
metal feet of the SDI-27
board.
4) With two of the screws
supplied with the DSBK-
120/120P, fasten the SDI-
27 board to the DV-15
board (in the same way as
you fastened the SDI-28
board to the DV-15 board).
6
[DSR-85/85P]
Return the DDE-4 board to the
slot in the VCR.
[DSR-80/80P]
Return the DV-15 board to the
slot in the VCR.
18
SDI-27 board
Wire clip
SDI-27 board
Push down the levers at both
ends, and with both hands press
the board firmly into position.
Wire clips
DV-15 board
DV-15 board
SDI-27 board
Metal feet
DDE-4 board [DSR-85/85P]
DV-15 board [DSR-80/80P]