Safety Instructions - ABB FIO-01 Kurzanleitung

2
Quick guide - FIO-01
Introduction
This manual contains the very basic information about installing
the FIO-01 Digital I/O Extension. For complete documentation see
FIO-01 Digital I/O Extension User's Manual
[3AFE68784921 (English)]. To find the manual, go to
http://www.abb.com/

Safety instructions

WARNING! All electrical installation and maintenance work on the
drive should be carried out by qualified electricians only.
The drive and adjoining equipment must be properly earthed.
Do not attempt any work on a powered drive. After switching off
the mains, always allow the intermediate circuit capacitors to
discharge for 5 minutes before working on the frequency
converter, the motor or the motor cable. It is good practice to
check (with a voltage indicating instrument) that the drive is in fact
discharged before beginning work.
These warnings are intended for all who work on the drive.
Ignoring the instructions can cause physical injury or death, or
damage the equipment.
For complete safety instructions see the drive manuals.
Mounting
WARNING! Before installation, switch off the drive power supply.
Wait for five minutes to ensure that the capacitor bank of the drive
is discharged. Switch off all dangerous voltages connected from
external control circuits to the inputs and outputs of the drive.
Quick guide - FIO-01
and search with the code 3AFE68784921.