Sony RM-450a Bedienungsanleitung Seite 28

Useful Editing
Performing assemble edit
Performing insert edit
28
Notes
• When the player is set in the playback mode, the playback signal of the
tape is supplied to the recorder.
Therefore, to edit a live source from a video camera, set the player in the
STANDBY OFF mode by pressing the STDBY button.
• When the player has a time base corrector, supply the same reference
sync signal to this unit and a camera or supply the video signal output
from a camera to the recorder.
RESET
HOURS
PLAYER
POWER
ON
STDBY
OFF
PLAY STILL REW
REVERSE FORWARD
SHUTTLE
2,3
1
Enter the IN point for the recorder.
2
Press the AUTO EDIT/END button.
Editing of signals from the camera begins.
3
Press the AUTO EDIT/END button when you find the scene for the
OUT point.
Editing is completed.
1
Enter the IN and OUT point for the recorder.
2
Press the AUTO EDIT/END button.
Editing of signals from a camera begins and is automatically
completed.
Entering the edit points in the insert mode
You do not need to enter the OUT point in the insert mode either. Press
the AUTO EDIT/END button when the scene for the OUT point is found.
SERVO IN OUT IN OUT
MINUTES SECONDS FRAMES EDITING CONTROL UNIT RM-450A HOURS MINUTES SECONDS FRAMES
EJECT ASMBL V A1 A2
EDIT MODE
– +
FF
AUDIO SPLIT TRIM LAST EDIT
IN OUT GO TO IN OUT
PLAYER RECORDER
ENTRY
JOG
AUTO EDIT RVW
PREVIEW ALL STOP
/END /JUMP
SERVO
RESET TOTAL
RECORDER
REC EDIT STDBY EJECT
PLAY STILL REW FF
REVERSE FORWARD
1
SHUTTLE JOG