Silvercrest 322055 Bedienungs- Und Sicherheitshinweise Seite 33

2. Point the remote control at the
remote-controlled socket at a
distance of approx. 50 cm.
3. Push the respective ON button
of the Channel ON/OFF but-
ton 2 (A, B, C or D) on the
remote control. You can now
remotely switch a connected
device on or off. Once assigned
the process will complete.
4. Repeat step 1 – 3 with the
other wireless socket.
Note: You can switch several
remote-controlled sockets on
and off at the same time using
the ON/OFF button 2 of one
channel. In addition, you can
programme six remote controls
one after the other and use
them for individual receivers.
This means you can switch one
appliance on and off from up
to six different places. In this
case, synchronise every remote-
controlled socket with the chan-
nel of the remote control.
Note: The coding of the remote
control is maintained when you
change the battery.
Note: If you disconnect the re-
mote-controlled socket from the
power supply, the codings will
be permanently stored.
However, the remote control
cannot be used for at least
30 seconds after the connection
is renewed, as this can cause
new encoding to take place.
Deleting a code:
First repeat steps 1 – 2 to
delete a code.
Then push the desired OFF
button of the Channel ON/
OFF button 2 (A, B, C or D)
you wish to delete on the
GB 33