Inhaltsverzeichnis
Werbung
Removing the Mask
To keep your adjustments, remove the mask by unclasping the magnetic clips from the magnetic
clip receivers and pulling forward away from the nose. Then pull the cushion and mask up and off of
10
the head.
5 Mask Care
Cleaning Instructions
Daily:
Hand wash the non-fabric parts.
Weekly:
Hand wash the fabric parts.
Caution
•
Do not place the fabric parts into a clothes dryer.
•
Any deviation from these instructions may damage the product.
•
Do not use bleach, alcohol, cleaning solutions containing bleach or alcohol, or cleaning
solutions containing conditioners or moisturizers.
1. Disassemble the mask (see Disassembly section).
2. Submerge and hand wash the mask components in warm water with liquid dishwashing
detergent.
Note:
Ensure there are no air pockets present inside the mask parts while submerged.
3. Rinse thoroughly.
4. Lay the headgear and fabric sleeves flat or line dry. Make sure the entire mask is dry before use.
Dishwashing Instructions
In addition to hand washing, the mask may be cleaned in the dishwasher once a week.
Caution
•
Use a mild liquid dish washing detergent only to wash the mask.
•
Do not use the drying cycle on the dishwasher.
•
Do not use bleach, alcohol, cleaning solutions containing bleach or alcohol, or cleaning
solutions containing conditioners or moisturizers.
1. Remove the fabric parts. Do not wash the fabric parts in the dishwasher.
2. Disassemble the mask (see Disassembly section).
3. Wash in the top shelf of the dishwasher.
4. Air dry. Make sure the mask is dry before use.
6 Assembly and Disassembly
Assembly
Tip:
Align the cushion and frame for
proper assembly.
1. Cushion: Press into the mask frame.
Note:
The cushion and frame will fit tightly
together without any gaps. If there are
any gaps or leaks between the frame and
cushion remove the cushion and reattach.
The cushion should fit securely in the frame.
2. Sizing connector: Click the mask frame
tubes into the sizing connector.
3. Elbow: Insert into the top of the frame
14
size connector.
4. Tubing quick release: Push the tubing quick release onto the elbow until it clicks into place.
5. Magnetic clips: Push the back circular end of the magnetic headgear clip into the mask frame
bottom slot until it clicks into place.
circular end. The clip will snap into place when the magnetic ends are connected.
11
11 12
14
13
15
Connect the front end of the magnetic clip to the back
4
12
13
15
16
14
16
Werbung
Inhaltsverzeichnis
