Blaupunkt BPPT-001 Bedienungsanleitung Seite 10

Inserting drill bits / screwdriver bits
• To insert a drill bit / screwdriver bit, hold the back section of the chuck and rotate the front section of the chuck
• Insert the drill bit / screwdriver bit into the chuck ( as far as possible )
• For screwdriver bits use an adaptor
• Select the correct screwdriver bit to avoid damaging the screw
• Firmly tighten the chuck by hand and check if the drill bit / screwdriver bit is seated firmly in the chuck
1. Front section of chuck
2. Back section of chuck
On/off switch
• To switch on the tool, press the on/off switch
• To switch off the tool, release the on/off switch
Left/right switch
/ shown on the left/righ switch
Set the Left/right switch to
Set the Left/right switch to
• Change the direction of rotation only when the machine is not in operation !
Caution
• Operating the machine with a low speed for a long time will increase the risk that the motor will be overheated.
To prevent overheating, let the motor cool down regularly ( Stop using the machine for 15 minutes )
Variable speed
• Applying more pressure to the On/off switch will increase the speed.
• Applying less pressure to the On/off switch will decrease the speed.
Lower/higher Speed selecting:
• Lower speed: switch Speed convert button to position 1.
• Higher speed: switch Speed convert button to position 2.
8
1
2