Klarstein 10009784 Bedienungsanleitung Seite 19

5. Cleaning of Dust Box
1. Power off. Put the Robot Vacuum Cleaner on a flat surface, with its soffit upwards.
2. Take away the cover to the dust room, as shown on the following figure.
3. Using the Clean Brush or Spoon, clean unwanted objects within the dust box or over leaves
to ensure air ventilation.
4. During installation of the cover, take note to align the clamps before pressing down.
6. Replacement of Battery
Battery replacement for machin
1. With the help of a screw- driver raise both end
snaps of the battery and vertically lift up the batteries
(Refer to Fig 1 & Fig 2)
2. Match the electrodes during installation, otherwise
wrong polarity may result in damage to the machine.
Battery replacement for Space Isolator:
1. Using a screwdriver, loosen the bolts on battery
cover and open the cover (as shown on Fig 1).
2. Match the electrodes during installation, otherwise
wrong polarity may result in damage to the Space
Isolator (as shown on Fig 2).
3. Correct position of batteries (as shown on Fig 3).
4. Take out batteries in case of long time of no using
the Space Isolator.
Battery replacement for Remote Control:
1. Using fingers, open the battery cover and expose
the battery case (as shown on Fig 1).
2. Match the electrodes during installation, otherwise
wrong polarity may result in damage to the Remote
Control (as shown on Fig 2).
3. Take out batteries in case of long time of no using
the Remote Control.
1. Take out batteries in case of no more use of the machine.
2. Power off first, before taking out the batteries of the machine and the Space Isolator.
Fig 1
Fig 1 Fig 2
Fig 1
Fig 2
Fig 3
Fig 2
19