Cleaning & Maintenance - Klarstein 10009784 Bedienungsanleitung

3. In order to make the Robot Vacuum Cleaner start to clean completely following the set time,
charging must be made by the charging dock station, and direct connection to the Battery
Charger for charging will not realize auto cleaning. At the set time, if the battery is not fully
charged or continuously charged for less than 5 hours, the timing function will not be activated.
In other words, the set time must be at least 5 hours later, and will not work if set as within 5
hours. At the same time of timing, charge the cleaner via the charging dock station, or the timing
function will fail;
4. At "Timer" status, please close the auto function during charging of the cleaner, otherwise the
cleaner will assign priority to exercise the auto function after full charge, and automatically
leaving from the charging plate for cleaning, resulting in failure of the Timer function.
5. In the period from completion of timer setting to the set time, the charging dock station cannot
be power off, or both the "Hour" and "Timer" need be reset.
1. Empty the Dust Box
① Power off
② Press the button on the dust box and pull out the dust box, as shown on the following figure.
③ Empty the dust box.
④ Slightly press the clamp at the dust box, and put back the dust box.
2. Cleaning of Filter Mesh
① Turn over the dust box, with its bottom upwards.
② Slightly press the protrusion at the bottom to take out the Filter mesh, as shown on the following
figure.
③ Clean dust on the Filter mesh.
④ Re-install the Filter mesh into the dust box.
Cleaning & Maintenance
17