IKEA UPPLEVA 24 Bedienungsanleitung Seite 12

Advanced), then configure proper
cable information as described
below. Use the digit buttons to
adjust the values of frequency,
symbol rate and network ID; use /
to select a modulation mode.
•
Press OK to start initial setup
relating to all DVB-C digital and
analog channels.
Note: To prevent the channel setup
process from being interrupted, wait for
the message indicating that the setup is
complete.
4. Before starting the scanning, you can
also select Skip Scan to skip the initial
setup process.
5. During the setup, you can follow the
hints available at the bottom of the
screen to return to the previous step by
pressing BACK. Or press EXIT to exit or
interrupt the search halfway.
6. Once the automatic search ends, the set
enters the next step automatically. You
can press /
Shop or Home. Press OK/ to confirm
your selection and enter the last step.
7.

In this step, you can press
exit the initial setup. The channels
are arranged in a preset order. If
you wish to skip channels, modify
the preset order or rename channels,
select SETUP > Organiser and press
OK/ to enter.

In this step, you can also press
to return to the previous step.
Automatically install channels
This section describes how to search and
store channels automatically. Instructions
are for both analog and digital channels.
1. Press MENU on the remote control and
select SETUP > Language > Menu
Language. Press / to select your
desired menu language.
BACK to return to SETUP, press
2. Press
/ to select Country, then press /
to select your country. The TV installs
and arranges channels according to your
country.
3. Press / to select Tuner Mode, then
press / to select Air or Cable.
to select your location
OK to

Select
•
Press
Install, and press OK/ to enter.
•
Select
to Figure 2.), then press OK/ to
display Automatic Search.
•
Press
selection and
Or
then press OK to enter.
•
Select
Analog, then press OK/ to start
the automatic search, which relates
to all DVB-T digital and/or analog
channels.

Select
•
Press
Install, and press OK/ to enter.
•
Select
press OK/ to display Automatic
Search.
•
Press
selection and enter the next step.
Or use / to reselect your country,
then press OK to enter.
•

Select
press OK/ to enter. Select your
scan mode if available and configure
proper cable information in the
same way as in initial setup. Select
Scan and press OK/ to start your
automatic search relating to all
DVB-C digital and analog channels.

BACK
Select
same process as above to start
your automatic search relating to all
DVB-C digital channels.

Select
start your automatic search relating
to all analog channels.
4. The search may take a few minutes.
During the process, you can press EXIT
to abort halfway.
5. Once the automatic search ends, press
BACK to return to the previous step or
press OK to restart your channel search.
6. After the automatic search, channels are
arranged in a preset order. You can skip
channels, modify the preset order or
rename channels.
Air.
/ to select Channel
Automatic Search (Refer
OK to skip the country
enter the next step.
use / to reselect your country,
Digital & Analog, Digital or
Cable.
/ to select Channel
Automatic Search, then
OK to skip the country
Digital & Analog, then
Digital, then follow the
Analog, then press OK/ to
11