3. Installing the Scale
3-1. Installation Precautions
3-1-1. Checking the Installation Direction
Check that the scale is installed in the positional relationship shown in Fig. 3-1.
Except when installed on a vertical axis, only the orientation in Fig. 3-1 should be used.
If installing on a machine tool or other equipment where powder and dust occur, install using the A orientation
since this allows usage of cutting fluid and prevents the intrusion of cutting dust.
Install using the B orientation only in other situations when virtually no foreign objects can enter the scale.
A
B
OK
Conditional
Fig. 3-1. Scale installation direction
Installing on vertical axis
If installing on a machine tool or other equipment where powder and dust occur, install so that the scale
slider is facing the opposite direction of the machining tool (cutting tool).
Slider
Scale unit
Cutting tool
Fig. 3-2. Scale installation position and direction for the vertical axis
3-1
BL55-RU
(E)