Names And Functions Of Parts; Scale - Sony BL55-RU Bedienungsanleitung

2. Names and Functions of Parts

2-1. Scale

4 Air inlet
1 Slider
The slider has a built-in detector head. The slider is secured in place by the slider holders at shipping.
2 Scale unit
The scale unit incorporates a high-accuracy LASERSCALE. It is protected by an aluminum cover.
3 Foot plate
This is used to secure the scale in place.
The number of attached foot plates varies depending on the scale measuring length.
Measuring length of 470 mm or less ........................ None
Measuring length of 520 mm to 920 mm ................. 1
Measuring length of 1020 mm .................................. 2
4 Air inlet
This is used when air is injected.
To inject air, remove the hex.socket-head set screws covering the inlets, and then attach the hex. socket-
head half-union.
5 Model name and Serial No.
This indicates the model name and serial number.
Be sure to always use scale and interface units that have matching serial numbers.
6 Connector
Connect the head cable for linking with the interface unit.
The connector has an antistatic connector. Do not remove this connector until you are ready to connect
the interface unit.
Also, after removing the antistatic connector, be particularly careful not to touch the connector pins.
Touching the connector pins can damage the scale.
BL55-RU
3 Foot plate
2 Scale unit 1 Slider
Fig. 2-1. Scale
5 Model name and Serial No.
BL55-RU
XXXXXX
6 Connector
2-1
(E)