Philips HD 3410-12 Bedienungsanleitung Seite 5

- Mount the separately packed supports with
wheels (figs. 3 - 6).
Tighten the winged nuts well using a pair of
pliers. Check if the supports are correctly fixed.
- Put the heater into normal position. Wait for at
least three minutes before connecting up and
switching on.
How to use
Power setting
Higher power settings result in quicker heating.
- Set switch (A) to position "on" (•) (fig. 7) for low
power.
- Set switch (B) to position "on" (••) (fig. 8) for
medium power.
- Set both switches (A) and (B) to position "on"
(• ••) (fig. 9) for high power.
Setting the temperature
- Set the thermostat by means of knob (C)
(fig. 10). (Position 10 = maximum,
position 1 = minimum.)
After this, the heater will keep its environment
at the set temperature by switching on and off
at intervals.
When a heating element has been switched on by
the thermostat the pilot lamp in the corresponding
switch (A) and/or (B) will illuminate.
You can adjust the thermostat knob setting during
use.
A good way of finding the ideal thermostat knob
setting for you is as follows:
- First set the knob to position 10 (= maximum).
- As soon as the temperature is comfortable, turn
down the thermostat knob slowly until the
heater goes off.
Cleaning
- Before cleaning turn the heater off and remove
the mains plug from the wall socket. Wait for
the heater to cool down sufficiently.
- You may clean the outside of the heater with a
damp cloth. Make sure that no water runs into
the appliance.
* The vents (E) may be cleaned using the
vacuum cleaner with small long-haired nozzle.
Non-rewireable mains plug (for Hong Kong
only)
This appliance is supplied with a round-pin type
earthed non-rewireable 15 Ampere fused plug. If
the supplied plug is not suitable for the socket
outlets in your home it can be removed and an
appropriate one fitted. (See below ).
Please note: Do not connect the supplied
15 Ampere round-pin type plug to a socket for flat-
pin type plugs via a "multiplug" adapter.
For U.K. only:
The appliance is supplied with a non-rewirable 13
Amp. plug.
The plug must never be used without the fuse
cover being in place.
If a replacement fuse cover is required, it must be
of the same type or colour as the coloured insert
around the fuse cover.
Replacement fuse covers are available from
Electrical Retailers or direct from Philips, tel.
0181 - 689 - 2166, ext. 8014.
Replacement 13 Amp. fuses must be BSI or
ASTA BS 1362 approved.
Important safety information
If the non-rewirable plug is not suitable for the
socket outlets in your home, it can be removed
and replaced by a plug of the correct type.
The non-rewirable plug must be cut from the
mains cord, the fuse removed, and the plug safely
discarded to prevent further use.
The removed plug can be hazardous if inserted
into a live mains socket.
Wiring Instructions (for U.K. only):
please refer to page 2
5