Address Setting For Rs485 Bus Operation, 2-Wire; Address Setting For Clock / Data; Communication Interface And Protocol Selection - Siemens AR6181-RX Einbau- Und Inbetriebnahmeanleitung

5.2.1

Address setting for RS485 bus operation, 2-wire

5.2.2

Address setting for Clock / Data

5.2.3

Communication interface and protocol selection

Siemens Building Technologies
Fire Safety & Security Products
All card readers are issued with an individual address as shown in table 2.
The address option of the reader interface and door controller must be considered.
DIP 1 DIP 2 DIP 3
off off off
off off off
off off on
off off
on
off on off
off on off
off on on
off
on on
on off off
on off off
on off on
off
on on
on on off
on on off
on on on
on on on
Bus address: addressing into account to the interface.
Tab. 2
There is no need to select a reader address when the Clock / Data interface is
used. The Clock / Data interface allows only one reader to connect with the reader
interface.
DIP 4 DIP 5 DIP 6
off off
on
on on off
Tab. 3: Address using Clock / Data interface
The communication interface has to be selected either to communicate with
intelligent controllers or via RS485 bus to connect to a reader interface or Clock /
Data interface.
Within the communication interface there are different protocols selectable.
DIP 4 DIP 5 DIP 6 Communication Interface Protocol
x off off
x off
on
off on off
on on off
x on on
x – don't care, see tab. 2
Tab. 4: Selection of communication interface
DIP 4 Bus address
0 - 15
off 0
on 1
off 2
3
on
off 4
on 5
off 6
7
on
off 8
on 9
off 10
11
on
off 12
on 13
off 14
on 15
Communication
interface
Clock / Data interface
Clock / Data interface
RS485 bus operation
RS485 bus operation
Clock / Data Interface
Clock / Data Interface
RS485 point-to-point
Setting up
1 - 16
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Protocol
Wiegand
Omron (Magstripe Track II)
UCI reader protocol
CerPass reader protocol
Wiegand
Omron (Magstripe Track II)
Configuration mode
04.2005
13