Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Screw the Rubber Seal (E) for the Coupling Hose (22) into the Hose Swivel
(16). Use sealing tape to seal the threads, for example
Sealing Tape, Art.-No. 82 11 24.
Then screw the Spigot Coupler (D) onto a Tap that has a fitting with a ¾"
thread. Make sure that the Rubber Seal (E) is seated correctly in the Spigot
Coupler (D).
Next connect the Coupling Hose (22) to the Hose Coupler (20A), then the
Hose Coupler (20A) to the Spigot Coupler (D). – Ready!
Pull the Hose (19) slowly out of the Hose Reel (A).
You will hear a clicking noise with each turn of the reel.
If you stop pulling the Hose (19) after the second click it remains extended at
this extracted length.
To retract the Hose (19) back into the reel, pull the hose up to the last click of
the next turn and guide it slowly back into the reel.
Assembly
Operation
Do not let the hose go while it is retracting! Always hold
the end of the hose under all circumstances, otherwise
the retracting hose may fly around dangerously and
cause damage or injury.
7
Thread
Werbung
Inhaltsverzeichnis
