Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1
Installation
The system program (operating system/firmware) in the operator terminals
must be of the same version if IFC MC is used as a backup card to copy projects
or files between different terminals.
For information about making the operator terminal autoload from the memory
card, see section
Autoloading terminal projects from memory card
The memory card can only be read and written to by the terminal, and not by a
personal computer.
This chapter describes how to mount the memory card in the terminal.
1.1
Installation of one expansion card
Perform the following steps to mount the IFC MC expansion card:
1. Switch the terminal power off.
2. Make sure that the ESD protection is good.
3. Remove the cover plate on the rear of the terminal, and the two expansion
plates on the short side. In terminals equipped with two expansion slots, the
slots are called Slot 1 and Slot 2. In terminals with one expansion slot, it is
called Slot 1.
ABB, 1SBC159005M0401
Slot 2
Slot 1
Installation
in chapter 3.1.
7
Werbung
Kapitel
Inhaltsverzeichnis
