Yamaha PDM-4220 Bedienungsanleitung Seite 32

OPERATING INSTRUCTIONS (continued)
SETUP MENU (RGB mode: RGB1 (DVI-PC), RGB2 (RGB)) (continued)
Selected characters
Vertical Filter
Frequency Mode
RGB1
RGB2 (1st step)
RGB2 (2nd step)
• Depending on the type of signal displayed, displays may not be optimized through automatic adjustment. Adjust manually to optimize them.
Off On
Movie PC
DVI-PC DVI-STB
RGB Component
Auto HDTV SDTV/DVD
Setup hint
Turn On when concerned about screen flicker.
Set to Movie when viewing moving images on a personal
computer.
This should correspond to the signal mode of the signal from the
equipment that is connected to RGB1 DVI terminal.
This should correspond to the signal mode of the signal from the
equipment that is connected to RGB2 D-sub terminal.
This step should be set only when [Component] is selected on
the 1st step.
This should correspond to the signal mode of the signal from the
equipment that is connected to RGB2 D-sub terminal.
• Normally, set this to Auto. The signal mode of the input signal
will be automatically recognized.
• If the input signal contains much noise or has a low level at
Auto and the operation is found erratic, set this to match the
input signal.
31