Troubleshooting; Possible Cause - Silvercrest SSTB 10 A1 Bedienungsanleitung

Troubleshooting

This section contains important information on fault identifi cation and rectifi cation.
The following table will help to identify and rectify minor faults:
Fault
The device will not
switch on.
No sound.
The Bluetooth ®
connection cannot be
established.
The remote control
does not work.
SSTB 10 A1

Possible cause

The mains adapter is
not connected.
The socket is not supply-
ing any power.
The volume on the device
or the playback device is
set to minimum.
Playback has not been
started on the playback
device.
You have selected the
incorrect operating
mode.
is not
®
Bluetooth
activated on the play-
back device.
The playback device
is not paired with the
device.
The distance between
the device and the
playback device is
too great.
The remote control is
pointing the wrong way.
The distance between
the remote control and
the device is too great.
The battery in the remote
control is fl at.
Remedy
Connect the mains adapter correctly.
Check the house's mains fuse.
Increase the volume on the device or
on the playback device.
Start playback on the playback
device.
Check whether the correct operating
mode (AUX or Bluetooth
been set.
Switch on Bluetooth
®
playback device. Please refer to its
operating instructions for more infor-
mation.
Pair the devices again (see chapter
Pairing the device with a
® playback device).
Bluetooth
Ensure that the device is no more than
10 metres away from the playback
device.
Point the remote control towards the
infrared sensor on the front of the
device.
Move the remote control closer to
the device.
Replace the battery.
) has
®
on your
31
GB