Panasonic AW-HE50HE Bedienungsanleitung Seite 28

Genlock adjustment (AW‑HE50S only)
q Colour phase adjustment
w
The colour phase adjustment must be performed if the
pictures are to be switched using a video switcher or other
device when the video output signals have been set as
composite signals.
It need not be performed when the video output signals
have been set as component signals.
The camera's colour phase is aligned with the programme
output (split colour bar output) signals of a colour special
effect device or other colour tones that will serve as the
reference.
(The colour phase can be adjusted more accurately if a
vectorscope is used for the adjustment.)
When performing the operations
using the wireless remote control
1
Press the [MODE] button.
The mode is switched to the colour bar display.
2
Follow the operation steps in "Basic
operations" (page 31) to display the Top Menu.
3
Press the [] or [] button to bring the cursor
to "System".
To p M e n u
Came ra
Syst em
Main te n a n c e
Colour bar of camera
Split line
Colour bar of special
effects generator
S c e n e : F u l l A u t o
4
Press the [] button.
The "System" sub‑menu is displayed.
S y s t e m
G e n l o c k
O u t p u t
O t h e r
R e t u r n
5
Press the [] or [] button to bring the cursor
to "Genlock", and press the [] button.
The "Genlock" sub‑menu is displayed.
G e n l o c k
H o r i z o n t a l P h a s e
S u b c a r r i e r P h a s e
C o a r s e
F i n e
H P h a s e . S C F i n e S t e p
R e t u r n
6
Press the [] or [] button to bring the cursor
to "Coarse" or "Fine" of "Subcarrier Phase",
and press the [] button.
The "Coarse" or "Fine" value starts blinking.
7
Press the [] or [] button to change the
"Coarse" or "Fine" value of "Subcarrier
Phase", adjust the value so that the colour
phase is brought into alignment, and press the
[] button.
8
Press the [MENU] button for 2 seconds.
The menu display is exited.
9
Press the [MODE] button.
The mode is switched to the camera picture display.
27 (E)
0
9 0 °
0
1