Silvercrest SKT 2000 B1 Bedienungsanleitung Seite 10

RP100157 Konvektor Timer LB6 Seite 8 Mittwoch, 11. Juni 2014 12:39 12
Warning! Check that there is
sufficient distance from the wall,
fixtures and other appliances.
When setting up on the floor, the
distance must be at least 0.5 m to
exclude the risk of fire.
The distance to the wall must
always be observed unless you are
using the wall hooks supplied. The
wall should not be flammable.
2. Select a location in compliance with the
safety information
instructions" on page 4).
5.2 Mounting the appliance on a wall
Caution!
• The wall must not be flammable and
should also be strong enough.
• The appliance must be at least 10 cm
above the floor so air can circulate
freely.
Note: If you are mounting the appliance
on a wall, the feet must not be screwed on.
1. Screw the wall hooks supplied securely
to a wall suitable for this purpose:
– Mark the position of the two drill holes
so that the space between the wall
hooks matches the space between the
two slots on the rear of the appliance.
– Make sure that the two drill holes are
absolutely horizontal.
8
2. To ensure the appliance hangs vertically
(see "4. Safety
3. Hang the appliance from the wall hooks.
4. You can also screw the two spacers to
– Drill a hole around 40 mm deep using
an 8 mm bit.
– Insert a wall plug in each hole.
– Screw the two wall hooks in place
using the long screws.
on the wall, the two other wall hooks are
used here as spacers:
– Screw the two remaining wall hooks
to the underside of the appliance.
– Use the short screws for this purpose.
the wall to make the appliance even
more stable.