Connecting The Antennas - Yamaha RX-V630RDS Bedienungsanleitung

Connecting the antennas

Both AM and FM indoor antennas are included with this
unit. In general, these antennas should provide sufficient
signal strength.
Connect each antenna correctly to the designated
terminals.
AM loop antenna
(included)
EO
VIDEO
TUNER
AM
ANT
GND
DVD
75 UNBAL.
D-TV
/CBL
FM
ANT
MONIT
OUT
Ground (GND terminal)
For maximum safety and minimum
interference, connect the antenna GND
VIDEO
R OUT
terminal to a good earth ground. A good
earth ground is a metal stake driven into
moist earth.
75-ohm/300-ohm antenna adapter (U.K. model)
1
Open the cover of the
included 75-ohm/300-ohm
antenna adapter.
3
Lead wire
Cut the lead wire and
remove it.
4
Clamp with
Clamp
pliers.
with
pliers.
Insert the wire
into the slot.
Insert the cable wire into the
slot, and clamp it with pliers.
RX-V630RDS
Indoor FM
antenna
(included)
2
11 (7/16)
8 (5/16)
Unit:
6 (1/14)
mm (inch)
Cut the external sleeve
of the 75-ohm coaxial
cable and prepare it for
connection.
5
Snap the cover into
place.
I Connecting the AM loop antenna
1
Set up the AM loop antenna, then connect it.
2
Press and hold the tab to insert the AM loop
antenna lead wires into the AM ANT and
GND terminals.
3
Orient the AM loop antenna for the best
reception.
Notes
• The AM loop antenna should be placed away from this unit.
• The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this unit.
A properly installed outdoor antenna provides clearer
reception than an indoor one. If you experience poor
reception quality, an outdoor antenna may improve the
quality. Consult the nearest authorized YAMAHA
dealer or service center about the outdoor antennas.
CONNECTIONS
17