Inhaltsverzeichnis
Werbung
Installation instructions for Extreme combination heating kit"
d Before you begin
Read these instructions completely and carefully and then
proceed. Follow the instructions in the Installation Manual too.
d Warning
-
The appliances are top heavy and must be secured to
prevent the possibility of tipping forward.
-
Keep doors closed, until the appliance is completely
installed and secured as per installation instructions.
-
Due to the weight and size of this appliance and to
reduce the risk of personal injury or damage to the
product, AT LEAST TWO PEOPLE ARE REQUIRED FOR
PROPER INSTALLATION.
Note:
-
The extreme combination heating kit is used, if the gap
between the appliances is less than 160 mm when mounting
using a partition.
-
When dimensioning partition for the installation example 4 is,
note the thickness of the furniture fronts and the dimensions of
the appliance handles, in order to prevent damage when
opening the appliance doors at the same time.
-
The minimum thickness of the partition is 16 mm.
-
In a Side by Side installation of the appliances (without
a partition) use the basic combination Side by Side sealing kit,
in order to securely connect the appliances with each other.
Required accessories and tools
Side extreme heating kit and the corresponding fitting instructions.
Installation Manual
Torx screwdriver T20
Torx Bit T20 and magnetic holder
Installation steps
Securing heating mat on the right side of the left standing appliance:
1. Insert pins through the prepared holes.
2. Pull the protective strip off from the adhesive tape on the
heating mat.
3. Insert pins into the upper holes whilst keeping the heating mat
from the appliance.
4. Press onto heating mat from top to bottom. Insert the lower
pins into the holes.
5
Werbung
Inhaltsverzeichnis
