The Editor Functions; Jump To Address; Display - Siemens MOBY STG Handbuch

The "MOBY D/E/F/I/U" Programs
4.4

The Editor Functions

4.4.1

Jump to Address

You can enter a memory address in decimal or hexadecimal format. The
setting can be changed under menu item Display/Display Address. This
address will then be represented by the editor as the start address.
This function can also be triggered directly in the editor with the "Tab" key.
4.4.2

Display

The following settings are available in this menu.
S Switch the editor between 32-byte representation (i.e., 4x8= fine-print
display) and 4-byte representation (i.e., 1x4= large, easy-to-read
characters).
S No address is displayed for editor representation 1x5. This display is very
good when reading fixed-code MDSs with the MOBY F. With other MDS
types, the first 5 bytes of the read data are displayed. You cannot change to
other addresses with the cursor.
S Switch the editor between hexadecimal and ASCII representation. The
addresses are always shown in hexadecimal or decimal format.
S Switch date between "BIN," "ASCII," "DEC" and "HEX" format.
E-28
STG Hand-Held Terminal
(5)J31069-D0126-U001-A5.2-7418
R 06.07