Commissioning the STG
2.3
Turning on the Device and Setting the
Operating Mode
Note
Before you turn on the device, insert the hand-held terminal in the
charging device (MOBY D/E/F/I) or connect to the power pack
(6GT2 503-1DA00) (MOBY U) and allow it to charge for at least
14 hours.
After charging, the hand-held terminal is ready for use.
After the terminal is turned on, initial startup takes several seconds. The MOBY
application then starts automatically, and a selection menu appears with the
MOBY applications. Select the MOBY application for the RF read/write head or
the antenna which you want to use.
The device goes off automatically after no keys have been pressed for 5 min-
utes. When turned on again, the hand-held terminal continues with the same
screen it was displaying before it was turned off manually or automatically.
See chapter 6.5.
E-6
1)
MOBY filehandler for MOBY I
The MDS data are accessed by file
names. See chapter 5.
2)-6)Normal MOBY service and test pro-
gram for MOBY D/E/F/I/U. The MDS
data are accessed by physical addres-
ses. See chapter 4.
9)
The operating system of the hand-held
terminal is accessed with "Exit."
V)
Version indication in MOBY application
menu (not shown in selection menu)
(5)J31069-D0126-U001-A5.2-7418
R 06.07
STG Hand-Held Terminal