Inhaltsverzeichnis
Werbung
Using the Inflator
1. Attach the included air hose (11) to the quick inflator socket (7) of the
compressor.
2. Make sure the compressor is switched off (switch (4) in OFF position).
3. Connect the 12 V adaptor (9) to the cigarette lighter socket in your vehicle
or boot.
4. Select the desired adapter and attach it to the end of the hose. Connect
the hose with the item you intend to inflate (beach ball, air mattress or
similar).
5. Switch on the compressor. If the desired pressure is reached, switch off
the compressor with the switch (4).
Attention! Please keep an eye on the item while it is inflating to prevent
over inflation.
6. After each use, store the accessory at the storage pocket (1) and close the
lid.
Using the Deflator
1. To deflate an item quickly, connect the included air hose (11) with the
quick inflator socket (8) of the compressor.
2. Proceed as described in the chapter "Using the Inflator".
Using the Emergency Light
1. To use the light, press the switch (5) in direction
LIGHT for bright light FLASH for flashing light OFF for switching off.
2. Open the emergency lens (6) in order to use the unit as a work light.
Changing the Illuminant
Make sure the illuminant has cooled down completely and the compressor is
switched off before changing the illuminant.
1. To change the illuminant, first open the emergency light.
2. Insert a screwdriver into the provided corresponding hole at the side and
lever out the transparent lid.
3. Turn the illuminant lightly to the left or to the right and pull the illuminant
out of the bulb socket. The illuminant has a bayonet coupling.
4. Insert a new illuminant of the type 12V/10W, bulb socket BA15 into the
socket. To lock the illuminant, lightly turn it to the left or to the right.
5. Place the transparent lid with the convex side on the lamp holder. Press
the edge down until the lid audibly locks.
Start-Up and Operation
10
Werbung
Inhaltsverzeichnis
