Inhaltsverzeichnis
Werbung
Notes
Do not inflate objects to a pressure for which they are not intended.
Do not inflate larger objects such as truck or tractor tyres or inflatable
boats. These exceed the permissible operating time range and the
compressor capacity.
In such a case use a suitable inflator to complete the required pumping
process.
Using the Air Compressor
1. Open the storage pocket (1) and remove the 12 V power cable (9) and the
air hose (10).
2. Make sure the ON/OFF switch (4) is in position OFF.
3. Connect the 12 V power plug to the 12 V cigarette lighter socket in your
vehicle or boat.
The included adaptors (11 – 14) are suitable for different applications
(e.g. football, volleyball or inflatable bed).
4. Attach the desired adaptor to the quick coupling and tilt the
lever down.
For inflating a tyre an adaptor is not required (lift lever up,
insert quick coupling to the tyre valve, press down lever).
5. Press the ON/OFF switch (4) to the position ON.
See the air pressure on the pressure gauge (3).
Note: This gauge is not calibrated. It is recommended to
check the air pressure with a calibrated air pressure manometer before
driving.
Attention! Please keep in mind that smaller items such as volleyballs or
footballs are filled very quickly. Do not leave the compressor unattended
while it is in operation. Make sure the sockets (7 and 8) are not blocked
while the compressor is in operation.
6. Do not use the compressor for more than 10 minutes continuously and
allow it to cool down for at least 15 minutes before using again.
7. When the item is fully inflated, first switch off the compressor. Disconnect
the quick coupling and the power plug from the cigarette lighter socket.
8. Store the accessory at the storage pocket and close the lid. The lid fits in
both directions. First, insert the pins into the compartment opening and
press the lid down until it audibly locks.
Start-Up and Operation
9
Werbung
Inhaltsverzeichnis
