ABB FEN-11 Kurzanleitung Seite 3

• Endat 2.2 with Sin/Cos signals (partially without Sin/Cos
signals)
• Hiperface
• SSI with Sin/Cos signals (partially without Sin/Cos signals).
Check compatibility.
TTL Encoders
• TTL incremental encoder, 1...65535 pulses / rev, supports
reference mark
Setting the supply voltage X301
Warning! Selecting the wrong supply voltage may damage or
break the encoder.
The supply voltage for an absolute encoder and a TTL encoder
can be selected by vertically mounted jumpers as described by
the following figure.
TTL Encoder (X41)
+24 V
Note: If an external power supply is used, the appropriate jumper
must be removed.
Note: If another FEN interface's TTL emulation output is
connected to TTL input, the appropriate jumper must be removed.
Absolute encoder (X42)
+5.5 V +5.5 V +8 V
Quick guide - FEN-11
3