Safety Instructions - ABB FEN-11 Kurzanleitung

2
Quick guide - FEN-11
Introduction
This manual contains the very basic information about installing
the FEN-11 Absolute Encoder Interface. For complete
documentation see FEN-11 Absolute Encoder Interface User's
Manual [code: 3AFE68784841 (English)]. To find the manual, go
to http://www.abb.com/

Safety instructions

Warning! All electrical installation and maintenance work on the
drive should be carried out by qualified electricians only.
The drive and adjoining equipment must be properly earthed.
Do not attempt any work on a powered drive. After switching off
the mains, always allow the intermediate circuit capacitors 5
minutes to discharge before working on the frequency converter,
the motor or the motor cable. It is good practice to check (with a
voltage indicating instrument) that the drive is in fact discharged
before beginning work.
These warnings are intended for all who work on the drive.
Ignoring the instructions can cause physical injury or death, or
damage the equipment.
For complete safety instructions see the drive manuals.
Compatibility
Absolute Encoders
• Sin/Cos incremental encoder, 1...65535 pulses / rev, supports
reference mark and Sin/Cos commutation signals
• Endat 2.1 with Sin/Cos signals (partially without Sin/Cos
signals)
Quick guide - FEN-11
and search with the code 68784841.