HANSGROHE PuraVida iControl mobile 15776 Serie Gebrauchsanleitung, Montageanleitung Seite 19

Transmitter:
Magnet:
English
Fittings
The transmitter is already trained to the receiver
when the parts are delivered. The transmitter can
be allocated to the receiver based on their identi-
cal serial numbers.
Additional transmitters or those purchased later,
must be trained Es A maximum of four transmit-
ters can be trained or saved. (see page 22 Login
mode).
The radio frequency of the transmitter is 868.3
MHz.
Note: Correct procedure to replace a defective
transmitter with a new one:
1. Delete all transmitters. (Login mode ⇒ Delete
mode).
2. Retrain all transmitters except for the defective
one. (Service mode ⇒ Login mode).
Material
Wood, gypsum, glass
(uncoated, without metal)
Brick, particle board plates
Concrete with iron reinforcement
Metal, aluminium lamination
In order to activate the service mode, the magnet
must actuate the REED contact (behind the rosette).
(see page 21 / 22, Service mode).
Assembly see page 209
Note: The receiver and the transmitter have a
range of approx. 10 m. This range depends on how
strongly the radio signals are dampened between
the transmitter and the receiver.
Note: For safety reasons, use the transmitter only
in the visual area of the shower system. Otherwise,
the water may be turned on accidentally.
Damping
0 - 10 %
5 - 35 %
10 - 90 %
90 - 100 %
REED contact
19