Parkside PLSA 40-Li C2 Originalbetriebsanleitung Seite 41

During work, ensure that the device
is not struck against hard objects,
which can cause damage. Do not suck up
any solid bodies such as stones, branches
or pieces of branch, fir cones or similar,
since these can damage the device, in
particular the shredding mechanism.
Repairs of this type are not covered
by the guarantee.
Blowing operating mode:
For safety reasons, make
sure that the protective cover
( 7) is inserted onto the
A
suction aperture.
• You get optimal results when you use
the blower with a separation distance
to the ground of 5 -10 cm.
• Begin work with the highest blowing
power, in order to rapidly pile up the
leaves lying around. Select a lower
blowing power to compact the previ-
ously piled up leaves.
• Before blowing, loosen leaves adher-
ing to the ground with a broom or
rake.
• The guide rollers at the end of the tube
make it easier to work on flat surfaces.
• Hold the device by the handle (2)
when working.
•
Working with two/three
blowpipe sections: With two
blowpipe sections mounted, you can
collect leaves over a wider area.
The third, smallest, blowpipe section
functions as a turbo nozzle (19). This
blowpipe section offers the highest air
speed.
Suction operating mode:
For safety reasons, all pipe
sections must be correctly
mounted before you can
start the device.
• Always hold the device tight with both
hands during operation: use the handle
( 2) and the additional handle
A
( 8) for this.
A
• Make sure the volumes of leaf material
sucked in at one time are not too large.
This will avoid clogging of the suction
tube ( 16) and blockage of the impel-
A
ler wheel.
To reduce wear on the collection
bag, do not drag it along the
ground while working.
Overload protection: The motor
will cut out immediately if overloaded.
Switch off the leaf vacuum and remove
the batteries from the device. Then check
whether the impeller is blocked or the
collection bag clogged and remove the
obstacles if they are.
The tool cannot be used until it has com-
pletely cooled down again.
Emptying the collection bag:
With full collection bag, the suction pump-
ing capacity decreases considerably and
the collection bag must be emptied when
the bag is full or interferes with the suction
capacity of the device.
1. Turn off the device and wait until the
impeller has stopped.
2. Remove the batteries (
device (see "Removing/inserting the
battery").
GB
5) from the
A
41