Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. Put the special tool (A) through the slots to prevent
movement of the tool plate.
5. Remove dust with the dust extractor.
6. Use a hex key to remove the 4 bolts that holds the
grinding disc.
7. Clean the tool plate with the dust extractor.
8. Attach a new grinding disc (B) and the 4 bolts.
Tighten the bolts with a hex key.
CAUTION:
flexible coupling is not damaged.
9. Remove the special tool.
2363 - 002 - 12.03.2024
A
B
Make sure that the
10. Carefully lift the product at the handlebar to
To adjust the handle and the
operation position
handlebar on page 10 .
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Do daily maintenance. Refer to
on page 16 .
3. Make sure that the product is assembled correctly
and is not damaged.
4. Put the product on the work area.
5. Make sure that there are diamond tools on the tool
plate and that they are tightly attached.
6. Connect the dust extractor to the product. Refer to
To connect a dust extractor on page 15 .
7. Adjust the handlebar to set the necessary work
height.
8. Connect the power plug of the product into the mains
outlet.
9. Make sure that you know in which direction the
motor rotates.
Daily maintenance
13
Werbung
