Siemens SIMATIC HMI KTP400F Mobile Produktinformation Seite 7

Compatible HMI devices
The Connection box decentralized is compatible with the following HMI devices:
HMI device
SIMATIC HMI KTP400F Mobile 6AV2125-2DB23-0AX0
SIMATIC HMI KTP700 Mobile
SIMATIC HMI KTP700F Mobile 6AV2125-2GB23-0AX0
SIMATIC HMI KTP900 Mobile
SIMATIC HMI KTP900F Mobile 6AV2125-2JB23-0AX0
SIMATIC HMI TP1000F Mobile 6AV2145-6KB20-0AS0
KTP700F Mobile Arctic
Mounting the connection box
Mounting position
The connection box can be installed in any mounting position.
Clearance
At least 100 mm for unimpeded access to the interfaces; see
figure to the right.
Fastening the connection box
Example: Fastening to a cabinet wall.
1. Hold the connection box on the area where you want to mount
it.
2. Mark locations for the mounting holes.
3. Drill holes or threaded holes for the 4 cylinder head screws
according to your requirements.
4. Attach the connection box.
Setting the box ID of the connection box
Connection box decentralized
A5E52889212-AA, 09/2023
Article number
6AV2125-2GB03-0AX0
6AV2125-2JB03-0AX0
6AV2145-6GB06-0AA0
HMI device
SIMATIC HMI IWP10F Mobile WebClient
SIMATIC HMI KTP700F Mobile HW
SIMATIC HMI KTP700F Mobile HW/OR
SINUMERIK HT 2
SINUMERIK HT 10
SINUMERIK HT 10H
Set an individual box ID for each connection box.
Requirement
• The connection box is open.
• A suitable tool made of plastic
Procedure
Rotate the arrows of the rotary coding switch to
the required hexadecimal value using a suitable
tool.
Values from "00" to "FF" (0 to 255 in decimal
form) can be set with the rotary coding switches.
When setting the box ID:
• Use the value "00" only for the "Stop button
evaluated by safety relay" operating mode.
• The value "FF" (255) is reserved and may not
be used.
In the example on the left, the box ID is set to
"27H" (39 in decimal format).
Article number
6AV2145-6KM00-0AA0
6AV2145-8GB00-0AA0
6AV2145-8GB01-0AA0
6FC5303-0AA00-2AA0
6FC5403-0AA21-0AA1
6FC5403-0AA21-1AA1
All dimensions in mm.
7