Werbung
Unpacking Your Charger
Carefully unpack and inspect your charger. Familiarise yourself with
all its features and functions.
Ensure that all parts of the charger are present and in good
condition. If any parts are missing or damaged, have such parts
replaced before attempting to use this charger.
Setting up the Battery Charger
1. If fitted, remove any battery from the battery charger.
2. Insert the battery charger mains plug into a suitable mains socket.
Note: The red LED (2) on the battery charger will illuminate to indicate
that the battery charger is ready to charge the battery.
WARNING: Only use this charger to charge compatible batteries that
are specifically designed for this tool.
WARNING: The charger is designed for indoor use only, and must not
be used in damp or wet conditions.
Charging the Battery
WARNING: Failure to follow the correct procedure when charging
batteries will result in permanent damage.
Note: Normal charging time is 1 hour for a recently discharged battery.
However, if the battery has been left in a discharged state for some
time, it may take up to 1.5 hours to charge.
1. Slide a fully or partially discharged battery onto the battery charger.
2. Once charging commences, the red LED (2) will illuminate and the
green LED (3) will flash.
3. When the battery is fully charged, the green LED (3) will illuminate.
If the Battery is defective the red LED flashes!
Note: Make sure the battery and battery charger are lined up correctly.
If the battery does not slide onto the battery charger easily, don't force
it. Instead, remove the battery; check the top of battery and the battery
charger slot are clean and undamaged and that the contacts are not
bent.
Battery Charge Level: The battery has a built-in charge indicator.
Pressing on the (Test) button to the right will indicate the charge level.
Operation
11
Werbung
